该词条未找到_海词词典

您要查找的是不是：

This paper researches the communication in Pharos Remote Monitoring and Control System(PRMCS),the topology control algorithm of the communication based on Wireless Sensor Network(WSN) is presented. 研究航标遥测遥控系统的通信部分,提出基于无线传感器网络的通信拓扑控制算法。
Through the RTS/CTS handshake mechanism the distance of neighbors can be computed while the transmission power of data packet can be adjusted according to the topology control algorithm. 该协议基于RTS/CTS机制，引入拓扑控制算法，通过收集相邻节点的拓扑控制信息，调整节点信号覆盖半径，降低节点间干扰。
A Multi-Rate Aware Topology Control Algorithm in Mobile Ad Hoc Networks 一种多速率移动自组网中的拓扑控制算法
A Distributed Topology Control Algorithm for Self-Maintenance of the Minimum-Energy Property of a Wireless Networks Topology 一种可自维护无线网络拓扑最小能量特性的分布式拓扑控制算法
topology control algorithm 拓扑控制算法
topology control algorithms 拓扑控制算法
Correct control algorithm is the key of network congestion control. 因此,正确的控制算法是网络拥塞控制的关键。
The control algorithm uses the increase type PID control algorithm. 系统实时性和控制精度较高。
By using neighbor elimination scheme as well as RNG topology control，the transmission power of each node and the redundant broadcast messages are reduced. 该算法在RNG图的基础上，采用邻节点消除机制，有效降低了节点的传输功率及广播消息在网络中的转发次数。
So the adaptive character of the control algorithm has been enhanced. 将该算法应用到电控气动离合器操纵系统中并进行实验。
An intelligence PID control algorithm based on the expert system was discussed. 讨论了一种基于专家知识的智能PID控制算法。
Stability condition of the proportional control algorithm is given for a fixed target. 针对固定目标，文中给出了比例控制算法的稳定性条件。
The system is composted of a high accuracy thermocouple and a 8031 single chip computer while adaptive PID control algorithm is employed. 该系统由一个高精度的热电偶和8031单片机组成，采用自适应PID控制算法。
A new parameters adaptive PID control algorithm is put forward on the basis of Cohen Coon assignment formula. 在Cohe Coon整定公式的基础上 ;提出了一种参数自适应PID控制算法 .
First, the TCP theory and the key technology of TCP congestion control algorithm are researched in the thesis. 首先,对Internet中传输控制协议的原理以及TCP拥塞控制算法中的关键技术进行了深入探讨和研究。
First, the jitter control algorithm aims at smoothing the jitter variance with low queueing delay latency. 首先，延迟变异控制机制目标在低延迟代价条件下，减缓延迟变异。
On this basis, the basic model of main-shaft-less concave printer and ADRC are combined to get a new control algorithm. 在此基础上又将推导出的无主轴凹印机粗基本模型与AD-RC相结合，得出新的控制算法。
For to evaluate the various control algorithm, Spencer, et al. present a AMD benchmark model. 为了能对各种算法有一个公认的评价标准，美国Notre Dame大学Spencer研究组通过对主动质量驱动(AMD)控制的三层框架模型实验的数据分析，建立了AMD控制Benchmark模型。
Fuzzy control algorithm is programmed by Borland C++, control of inverted pendulum hardware system is realized. 利用Borland C++编写模糊控制算法程序，实现了倒立摆实物系统控制。
Optimized control models under PEM SPM EDM control algorithms are obtained. 给出了系统在PEM、SPM、EDM三种控制策略下的优化控制模型。