您要查找的是不是:
- Tin free, polishing anifouling composition with cuprous oxide. 含氧化亚铜的无锡自抛光防污涂料。
- PTFE matrix composites were fabricated using mixing nano sized powder process and vaporizing impregnant process. 采用溶剂蒸发法和固体纳米粉末混合法制备两种工艺制备了PTFE复合材料。
- There are mainly two methods to prepare nano sized titania, uch as vapor phase process and liquid phase process. 纳米钛白的制备方法大致可分为两类,即气相法和液相法,而液相法是研究的重点和热点。
- The color may change after contact with seawater due to cuprous oxide dissolution into the seawater. 在接触海水之后,由于氧化亚铜溶于海水之中会导致颜色改变。
- The supported cuprous oxide to visible light photocatalytic degradation for the methylene bule are reported. 报道了漂珠负载氧化亚铜可见光催化分解亚甲基蓝溶液。
- Cuprous oxide and zinc oxide can be recovered from waste copper catalyst by a wet process. 研究了以湿法回收利用废铜催化剂中的铜、锌制取氧化亚铜和氧化锌的原理以及最佳工艺条件。
- The results show that the hardness of composites fabricated with vaporizing impregnant process is much higher than that fabricated with mixing nano sized powder process. 结果表明在填料含量相同时,溶剂蒸发法制备的PTFE复合材料的硬度显著高于固体纳米粉末混合法制备的PTFE复合材料的硬度;
- Color, plus a few drops of copper sulfate test solution, namely, the red precipitate of cuprous oxide precipitate. 色,再加硫酸铜试液数滴,即析出氧化亚铜的红色沉淀。
- The type,reaction mechanism and application of nano sized semiconductor photocatalyst are reviewed.The improvement of photocatalyst is also discussed in brief. 对半导体光催化剂的类型、作用机理、应用及其性能改进作了综合评述。
- This might damage the delicate red cuprous oxide layer we need to make to solar cell work. 这可能破坏脆弱的红色氧化亚铜层我们需要作出的太阳能电池工作。
- Compared with pure PTT, the thermal stability, crystallization and tensile performance of the PTT/MMT composites are improved due to the introduction of nano sized DK2 MMT. 与纯PTT相比,由于MMT在PTT基体中达到纳米尺寸分散,PTT/MMT复合材料的热稳定性能、结晶性能和拉伸性能都得到了明显提高。
- The preparation of cuprous oxide by electrolytic process was studied with optimum conditions defined. 对电解法生产氧化亚铜进行试验研究,提出了电解法生产氧化亚铜的工艺方法,确定了最佳工艺条件。
- Research is focused on the composition and quantitative variation of heterotrophic bacteria attached on the surface of cuprous oxide antifouling paint. 研究了浸海氧化亚铜防污漆表面粘膜中异养细菌的组成和数量变动情况。
- The free electrons move into the saltwater, then into the clean copper plate, into the wire, through the meter, and back to the cuprous oxide plate. 自由电子进入盐水,然后把干净的铜板,到线,通过米,并回到氧化亚铜板。
- This is not the oxide we want, but it will flake off later, showing the reds, oranges, pinks, and purples of the cuprous oxide layer underneath. 这不是我们想要的氧化物,但它鳞片关闭后,显示红,橙,粉红色和紫色的氧化亚铜层下面。
- Fine particles of cuprous oxide (Cu2O) and titanium dioxide (TiO2) were prepared and applied as photocatalysts in the heterogeneous photocatalytic degradation of p-nitrophenol. 本研究分别采用自制的纳米TiO2和Cu2O研究对硝基苯酚的光催化降解。
- U.S., Germany, Republic of Korea and Taiwan.The enterprise executive standard of cuprous oxide was identified as the standardof the Ministry of Chemical Industry in March 1998. 台湾等国家和地区,其中氧化亚铜的企业执行标准已于1998年3月被化工部确认为化工行业标准。
- Ground-test results show that cupric oxide or cuprous oxide formed on the surface of copper may break off by atomic oxygen impacting, to contaminate other surfaces. 地面试验结果表明:生成的氧化铜或氧化亚铜在原子氧撞击作用下,从试样表面脱落,并沉积到其他试样的表面,从而对其他表面产生较为严重的污染。
- When sunlight hits the electrons in the cuprous oxide, some of the electrons gain enough energy from the sunlight to jump past the bandgap and become free to conduct electricity. 当阳光打电子,在氧化亚铜,一些电子获得足够的能量从阳光跳转过去的带隙,并成为免费进行电力。
- Using nitrates and etylene diamine tetra acetic acid(EDTA) as raw materials, Nano size La 0.8 Sr 0.2 FeO 3 powder was synthesized by EDTA complexing Sol Gel method at lower temperature. 以金属硝酸盐和乙二胺四乙酸 (EDTA)为原料 ;用EDTA络合溶胶 凝胶法合成了La0 .;8Sr0