您要查找的是不是:
- Power Supply Rejection: The ratio of the change in input offset voltage to change in power supply voltage producing it. 电源抑制比,输入失调电压变化量与引起该变化的电源电压变化量之比。
- However, also consider amplifier noise, input bias current, offset voltage, MDAC resolution, and glitch energy. 然而,也要考虑放大器的噪声、输入偏置电流、偏置电压、MDAC分辨率和毛刺能量等因素。
- Common Mode Rejection Ratio: The ratio of the input voltage range to the peak-to-peak change in input offset voltage over this range. 共模抑制比,输入电压范围除以该范围内输入失调电压峰峰值。
- Input Offset Voltage: That voltage which must be applied between the input terminals through two equal resistances to obtain zero output voltage. 输入失调电压,为了使输出电压为零,在运放两个输入端通过两个等值电阻所施加的电压。
- This offset voltage will be added to the voltage measurement. 该偏移电压将被叠加到电压测量值中。
- This error voltage is known as contact potential or offset voltage. 该误差电压就是所谓的接触电势或偏移电压。
- One disadvantage of this method of stabilization is the additional output noise and offset voltage caused by increased amplification of input-referred voltage noise and input offset voltage. 这种稳定方法的一个不足是:输入端的有关电压噪声和失调电压增大会额外地增加输出噪声和失调电压。
- This method reduces the offset voltage normally caused by device overmolding, temperature dependencies, and thermal stress. 这种方法可降低通常由器件超模压、温度依存性及热应力引起的剩余偏移电压。
- The thesis introduces analog multiplier MC1496 of motorola company mainly about its internal structure and setting of quiescent offset voltage and quiescent bias current. 介绍了MOTOROLA公司生产的集成模拟乘法器MC14 96的内部结构及静态偏置电压、电流的设置。
- The offset voltage adds directly to the signal voltage and can be modeled as an unwanted voltage source in series with the intended signal. 偏移电压被直接叠加到信号电压之上,可以被模型化为一个未知的电压源,与已知信号相串联。
- The circuit scheme is 1.5bit/stage not only reduces the interstage gain but also reduces the requirement for offset voltage in the comparator. 采用1.;5位/每级的结构,既减小了级间增益,又使电路对于比较器漂移电压的要求降到了最低;
- The poles in an individual relay will have similar offset voltages. 一个继电器中的闸刀具有相似的偏移电压。
- The contact potential or thermoelectric offset voltage is the key specification of a switch card designed for low voltage switching. 接触电势或热电效应偏移电压是设计用于低压切换的开关卡的关键技术指标。
- When determining the voltage burden of an SMU, the offset voltage on the voltage source range being used must be included. 在确定SMU的输入端压降时,必须包括电压源所使用量程的偏置电压。
- The thermoelectric offset voltage due to the switch card and the interconnecting cable may be compensated for by using a short-circuited channel to establish a zero reference. 由于开关卡和互连电缆引起的热电效应偏移电压可采用一个短路通道来建立一个零参考,从而进行补偿。
- Don't refer to this matter again, please. 请不要再提这件事了。
- The nonlinear controller is mainly composed of an extended state observer (ESO), an input reference signal tracking-differentiator (TD) and a nonlinear state error feedback (NLSEF) control law. 自抗扰控制器为非线性控制器,由跟踪微分器、扩张状态观测器和非线性状态误差反馈控制律3部分构成。
- I referred to my watch for the exact time. 我看了一下手表好知道准确的时间。
- Superior high-temperature performance is made possible through dynamic offset cancellation, which reduces the residual offset voltage normally caused by device overmolding, temperature dependencies, and thermal stress. 动态偏移取消保证了在高温下的良好性能,可降低通常由器件超模压、温度依存性及热应力引起的剩余偏移电压。
- Unique Hall element geometries and low-offset amplifiers help to minimize noise and reduce the residual offset voltage normally caused by device overmolding, temperature excursions and thermal stress. 独一无二的霍尔元件几何结构以及低偏置放大器有助于降低噪音,并降低通常由器件超模压、温度剧增和热应力引起的残余偏置电压。