您要查找的是不是:
- The stove and cylinder valve's copulae, use tie-in double pressurize device. 卡炉与气瓶阀门的接合部位采用接头双重密封装置。
- If user experiences any difficulty operating cylinder valve discontinue use and contact supplier. 如果使用者在操作气瓶阀时有困难,需停止使用,并与供应商联系。
- An acetylene cylinder valve should not be opened more than approximately1 1 /2 turns. 乙炔钢瓶阀门不能开启得超过大约11/2圈。
- Always pressurize a regulator slowly, while standing with the cylinder valve between you and the regulator. 总是站得使钢瓶阀门位于你和调整器之间,对调整器慢慢加压。
- Always open a cylinder valve slowly. Never crack open a hydrogen cylinder to clear the valve of dust, as the escaping hydrogen may ignite. 总是慢慢地开启钢瓶阀门。由于溢出的氢可能着火,禁止啪地一声打开氢钢瓶。
- At the end of the shift or work day, close the cylinder valve and bleed the pressure off the regulator and torch equipment. 在下班或工作日结束的时候,关闭钢瓶阀门,放出调整器和吹管设备内的压力。
- Recommended Closing Procedure: Close the cylinder valve tightly using a gloved hand. 推荐的关闭程序:用戴手套的手紧紧地关闭阀门。
- This partition should extend from the top of the panel to18 inches below the cylinder valve. 隔离物应该在钢瓶阀门下面,从控制板顶部伸出来18英寸。
- If user experiences any difficulty operating the cylinder valve, discontinue use and contact supplier. 如果用户在操作钢瓶阀门时遇到任何困难,停止使用,联系供应商。
- Proudly mainly engaged in full range of products Germany, Italy, two-wire hose Granville, CKD cylinder valve. 主要经营德国宝德全系列产品,意大利双威钢丝胶管,CKD汽缸阀门。
- Caution: If user experiences any difficulty operating a cylinder valve, discontinue use and contact supplier. 警告:如果用户在操作钢瓶阀门时遇到任何困难,停止使用,联系供应商。
- They are designed to provide a secondary seal in the event the cylinder valve develops leakage through the valve seat. 它们是设计用来在钢瓶阀门通过阀座产生泄露的情况下提供一个二次密封。
- Always close the cylinder valve when product delivery is not needed. Do not leave it open when the equipment is unattended or not operating. 当不需要产品输出时,总是关闭钢瓶阀门。当设备无人照管或没有运转时,不要让阀门开着。
- Always ensure that cylinder valve is closed, outlet seal is installed gas-tight, and protective cap is in place before shipping. 在运输之前,总是确保钢瓶阀门关闭、排气口密封安装正确和保护帽在正确的位置。
- Leaks occurring at the cylinder valve's pressure relief device, diaphragms, or valve to the cylinder connection cannot be repaired. 发生在钢瓶阀门的减压装置、横膈膜或阀门到钢瓶的接头处的泄露不能维修。
- Close the regulator. To close the regulator, turn the adjusting knob to the full counter-clockwise position. The regulator must be closed before opening the cylinder valve. 关闭调整器。要关闭调整器,把调整钮逆时针旋死。在开启钢瓶阀门之前,必须关闭调整器。
- Turn the adjusting knob clockwise and establish the required use pressure by referring to the low-pressure gauge. Make sure that the cylinder valve is easily accessible. 顺时针旋转调整钮,通过查看低压量表建立要求的使用压力。确认钢瓶阀门容易接近。
- To introduce the structure,performance of the cylinder valve of INERGEN fire extinguishing system ,and to analyse its performances of the adjustment ,action and safety. 介绍了烟烙尽灭火剂的组成、灭火机理、性能及对环境的影响,分析了河津电厂集控楼烟烙尽灭火系统的设计特点,指出了设计上的不足之处及改造方案。
- Open cylinder valves slowly and carefully after the cylinder has been connected to the process. 在钢瓶已经连接到过程后,慢慢地仔细地开启钢瓶阀门。
- NF3 cylinder valves are equipped with pressure relief devices consisting of a frangible rupture disc backed by a fusible alloy. NF3钢瓶配备有由易碎破裂盘及其后的易熔合金组成的减压装置。