您要查找的是不是：
- Repeat steps2-5 until proper sag is achieved, then replace the air valve cap. 重复2－步骤以达到最佳预压行程后，盖上气阀嘴帽。
- Repeat steps 2-5 until proper sag is achieved, then replace the air valve cap. 重复2－5步骤以达到最佳预压行程后，盖上气阀嘴帽。
- Locate the Schrader air valve on the shock and remove the air valve cap. 找到避震上的美嘴气阀，取下气阀帽。
- If multiple ETX/ETSX tanks are installed in the system, check pressure of each for possible air leaks. Be sure air valve caps are on tight. 如果在系统上安装了多个ETX/ETSX膨胀罐，则检查每个膨胀罐，看看是否有气体泄漏。确保塑料气体阀门盖是否拧紧。
- Replace the cylinder outlet seal and valve cap. 替换钢瓶排气口密封和阀门帽。
- air valve cap 气阀盖
- Smooth operation of throttle linkage and throttle body air valve. 节流连杆和节流体空气阀的平稳操作。
- Unthread the pump from the air valve and measure sag. 参考气压设定建议数值表打入相应气压以达到所需的预压行程。
- Equipped with air valve to ejecting the products by blowing. 配备吹气装置以便于脱模。
- Unscrew the Allen screw in the middle of valve cap and lift up the cap just enough to pick up the old diaphragm. 旋松阀帽中间的内六角螺丝，并且提起阀帽，正好足够拿走旧阀膜。
- All parts inside adopt the stainless steel, and are installed on the valve cap, maintenance is convenient. 内部零件全部采用不锈钢制造，并且安装在阀盖上，维修保养极为方便。
- Do not overheat cylinders to increase pressure or discharge rate. NEVER insert an object (e.g., wrench, screwdriver, pry bar, etc.) into valve cap openings. 禁止使钢瓶过热来增加压力或流速。禁止把物体（如扳手、螺丝起子、撬杆等）插入阀门帽地开口处。
- NEVER insert an object (e.g., wrench, screwdriver, pry bar, etc.) into valve cap openings. Doing so may damage the valve causing it to leak. 禁止把物体（如扳手、螺丝起子、撬杆等）插入阀门帽的开口处。这样做可能损伤阀门，导致泄漏。
- NEVER insert an object (e. G., Wrench, screwdriver, pry bar, etc.) Into valve cap openings. Doing so may damage the valve causing it to leak. 禁止把物体(如扳手、螺丝起子、撬杆等)插入阀门帽的开口处。这样做可能损伤阀门,导致泄漏。
- NEVER insert an object (e.g., wrench, screwdriver, pry bar, etc.) into valve cap openings. Doing so may damage the valve causing it to leak . 禁止把物体（如扳手、螺丝起子、撬杆等）插入阀门帽的开口处。这样做可能损伤阀门，导致泄漏。
- An overall air control for each pipe in each room is available by fitting an air valve at the hot water supply. 把空气阀安装在温水供给器时可综合处理各房间管路内的空气。
- Screw the FOX Racing Shox High Pressure Pump onto the air valve until the pump shows pressure on the gauge. Do not over-tighten. 把避震专用打气筒旋紧在气阀上直到避震气筒上的压力表有气压显示，不要过份旋紧。
- Technician was adjusting air valves on pallet elevator behind the safety guard. 该技工实际上是在调整安全装置后面的托盘货物升降机的气阀。
- AIR VALVE IS MADE UP OF UPPER VALVE SEAT, LOWER VALVE SEAT, 5 KINDS OF ACCURATE VALVE SLICE AND 25 SPRINGS. 该气阀是由上阀座、下阀座及大小5种精密阀片和25个弹簧等零件组成。
- Air valve and piston-type compressors are to the important components is one of the components easily damaged. 气阀是往复活塞式压缩机中的重要部件，也是易损坏的部件之一。
