您要查找的是不是:
- DC Voltage reference element 直流电压基准
- Vacuum tubes require DC voltage sources as well. 真空电子管也要求以直流电压为电源。
- voltage reference element 电压参考元件
- Frequency drifts due to: DC voltage, temperature, VSWR. 频率漂移跟直流电压、温度、驻波比有关。
- Use the reference element to specify a data source. 使用reference元素指定数据源。
- A plot of dc voltage or current versus time normally produces a straight line. 直流电压或电流与时间的关系图一般成直线.
- DC voltage is determined by AC voltage, inductance on the AC side, and load. 直流侧直流电压是由交流电压、电感及负载决定的;
- The Reference element specifies an individual reference. Reference元素指定单个引用。
- A phenomenon which occurs when excess DC voltage is applied to an LCD. 一现象哪个发生什麽时候过度直流电压被用于LCD。
- The DC voltage calibration room is by far the largest of the labs I visited. 直流电压校准室要比我参观过的实验室的大很多。
- DC voltage divider can be used to design lower voltage direct current power. 直流分压器集开关电源和电能变换于一身,可以被用来设计降压型直流电源。
- Design of a CMOS Band-Gap Voltage Reference with Low Drift of Temperature. 刘小杰。一种低温漂CMOS带隙基准电压源的设计。
- ReferenceElementRequired At least one Reference element is required. 至少应该有一个引用节点。
- To reduce the active power and DC voltage fluctuation and accelerate tracking speed during system start, this paper proposes a new strategy setting reactive power reference based on the error between the instantaneous active power and its reference. 为了抑制电压型PWM整流器直接功率控制中的有功功率、直流电压波动,加快系统的跟踪速度,提出了根据有功功率瞬时值与有功功率给定的差值设定无功功率给定值的新策略。 当有功功率瞬时值与有功功率给定的差值小于给定临界值时,无功功率给定值为零;
- The superior voltage stability of such a Josephson voltage standard has many applications in dc voltage metrology. 此约瑟夫森电压标准杰出的电压稳定性在直流电压计量中可以有许多应用。
- If the multimeter is used to measure DC voltage or DC carnet , we must be careful that the polarity is not reversed . 假如用万用表测量直流电压或直流电流,我们必须注意极性不可接反。
- A novel super performance CMOS voltage reference circuit was designed based on the theory of bandgap voltage reference. 介绍了带隙基准电压源的基本原理,设计了一种高精度带隙基准电压源电路。
- The minimum number of times the reference element type can occur on the element. 引用元素类型在元素上可以出现的最小次数。
- If the multimeter is used to measure DC voltage or DC carnet ,we must be careful that the polarity is not reversed . 假如用万用表测量直流电压或直流电流,我们必须注意极性不可接反。
- If the reference element has a phase of zero, compute the phase applied to element five when the beam is scanned 40o above the boresight axis. 如果参考单元的相位是零,计算第五单元当扫描视轴线以上40度的相位。