您要查找的是不是:
- Using tap water as working fluid. 使用自来水当工作液。
- ANALYSIS ON FLOW PERFORMANCES OF COMPOSITE WICK AND WORKING FLUID CHARACTERISTICS FOR CPL CPL复合毛细芯流动性能及工质特性分析
- For on-line calibration system of flowmeter, the working fluid flow is from the petroleum pipe line itself. 体积管工作时的液流,对于流量计在线检定系统,是来自输油管线本身;
- A CPL is designed and fabricated, and its working fluid charging system is designed and made as well. 本文实际制作了CPL系统,分析了在制作过程中的要点。
- The abnormal flow and heat transfer disciplinarian of the working fluid in CPL induce the CPL non-steady-operation. 诱发CPL不稳定性运行的因素是CPL管内流动和传热的异常变化规律。
- Conduct test on wastewater treatment, RO, Paint, phosphate, degrease, metal working fluid, cleanness. 常规测试包括废水处理;工业纯水;喷漆;磷化;脱脂;切削液;清洁度等.
- Conduct test on wastewater treatment, RO, Paint, phosphate, degrease, metal working fluid, cleanness. 常规测试包括废水处理,工业纯水,喷漆,磷化,脱脂,切削液,清洁度等.
- A mini-ejector and a heat pipe with capillary structure in this new system perform a flow cycle of the working fluid. 该系统利用喷射器代替压缩机,利用热管内的毛细芯实现工质循环。
- For HTD engines, auxiliary systems may need to be added to maintain high pressure working fluid. 为天地HTD引擎,辅助系统可能需要增加保持高压工作液。
- We should not use water base working fluid, if have to, we should make it in the underpressure condition. 因此,在低渗透砂岩气藏的开采过程中应尽量避免使用水基工作液,如果要用水基工作液,应使压差处于欠压状态。
- Metal Working Fluids and Related Materials, Classification for (05. 金属工作液和相关材料的分类(05。
- Rene Rieberer.CO2 as working fluid for heat pumps.Graz:Graz University of Technology,Doctor Thesis,December 1998. 管海清.;CO2跨临界循环膨胀机理与转子式膨胀机-压缩机研究
- The influences of working fluid, Fill Ratio of liquid and inclination angle on the thermosyphon operating were analyzed. 试验发现工质为水的热虹吸管的启动时间大于工质为酒精的热虹吸管;
- The fluid characteristics suggests the multi-stage superimposition of fluid and sharp cahnge of temperature. 成矿流体特征指示成矿机制为多期流体叠加,流体成分及温度发生过剧变。
- The rarefied gas flow around two-dimensional rectangular was simulated by Direct Simulation Monte Carlo (DSMC) method, using air as working fluid. 本文采用直接模拟蒙特卡罗方法对稀薄气体二维外部柱体绕流问题进行了数值模拟。
- The experimental study on characteristics of a swirl pressure nozzle was carried out with the water as the working fluid of atomization. 实验结果为旋流压力式雾化器的工业化设计提供了重要的实验依据。
- Optimum analyzer system will be applied for specified point, considering the fluid characteristics, measured components and purpose of measuring. 在规定的测量点,考虑到流体特性、被测组份及测量目的,应采用最适宜的分析系统。
- This paper reveals how to make use of these parameters to discover oil showing and identify fluid characteristics of r... 利用这些参数可发现储集层中不同性质的油显示及对储集层流体性质进行评价。
- Gas (working fluid) from entering the spiral cavity suction tank by compression and exhaust through the exhaust orifice discharge cavity. 气体(工质)由吸气腔进入螺槽内,经压缩后通过排气孔口和排气腔排出。
- The relation between the optimal efficiency and power output of the engines for an ideal or van der Waals gas as a working fluid is derived. 导出这类热机以理想气体或范德瓦耳斯气体为工质时的最佳效率与输出功率间的关系。