您要查找的是不是：
- spring loaded relief valve 弹簧安全阀
- EZ twist relief valve cover-quarter turn locking joint captures the spring load during repair to facilitate disassembly. 将安全阀阀盖扭转四分之一转,锁定连接恢复弹簧负载,使得维修期间便于拆解。
- spring loaded pressure relief valve 弹簧加载的压力泄放阀
- Kit consists of: Relief Valve Assembly, RV Spring, and RV Cover O-ring. 组件包括：安全阀总成，安全阀弹簧，和安全阀阀盖O形环。
- Remove the elbows from the relief valve base. 从安全阀底座拆卸弯头。
- Bolt torques control total spring load. 螺栓扭矩控制所有的弹簧负载。
- Clean or replace the relief valve seat. 清洗或更换安全阀阀座。
- Damage or fouled relief valve seat. 安全阀阀座损坏或受到污染。
- Damaged or fouled relief valve seat. 安全阀阀座受到损坏或污染。
- Key removable in locked position only. Spring loaded clip-in pawl. 只能在锁住位置时取出钥匙，弹簧加载的嵌入式掣子。
- Relief valve must be piped to a suitable drain. 安全阀必须配置通向适当排泄口的排泄管道。
- Install relief valve cover nut and tighten. 安装安全阀阀盖螺母,并加以紧固。
- Control supply line water pressure. Install a soft seated, spring loaded, check valve upstream of the assembly. 控制供应管道的水压。在总成的上游安装一个软阀座,弹簧负载止回阀。
- The delivery pressure acting on the spring loaded diaphragm throttles the balanced valve to control the pressure. 水输出压力在弹簧负载隔膜的作用下对平衡阀进行节流调节，以控制水压。
- To assemble the Relief Valve Assembly have a screwdriver ready. 准备好组装安全阀总成的螺丝刀。
- Cushion spring loaded plastic grips.Steel plate spring.Non-bevelled... 电子剪刀产品型号：Electronics ShearGround carbon steel blades.
- Spring loaded for fast closure, eliminating reverse flow slam and water hammer. 负载弹簧用于快速关闭,消除逆流冲击和水锤。
- Place the relief valve seat back into the chamber bore. 将安全阀阀座放回到镗孔内。
- Remove the relief valve hose from fitting below inlet ball valve. 从进口球阀下面连接件拆卸安全阀软管。
- Slide the diaphragm assembly into the relief valve seat. 将隔膜总成滑进到安全阀阀座内。
