您要查找的是不是：
- oil pump relief valve spring 油泵安全阀弹簧
- oil pump relief valve 油泵安全阀
- pump relief valve 泵安全阀,泵保险阀,泵排泄阀
- Remove the elbows from the relief valve base. 从安全阀底座拆卸弯头。
- Clean or replace the relief valve seat. 清洗或更换安全阀阀座。
- Damage or fouled relief valve seat. 安全阀阀座损坏或受到污染。
- Damaged or fouled relief valve seat. 安全阀阀座受到损坏或污染。
- Relief valve must be piped to a suitable drain. 安全阀必须配置通向适当排泄口的排泄管道。
- Install relief valve cover nut and tighten. 安装安全阀阀盖螺母,并加以紧固。
- To assemble the Relief Valve Assembly have a screwdriver ready. 准备好组装安全阀总成的螺丝刀。
- Place the relief valve seat back into the chamber bore. 将安全阀阀座放回到镗孔内。
- Remove the relief valve hose from fitting below inlet ball valve. 从进口球阀下面连接件拆卸安全阀软管。
- Close valve fully three times for three seconds and record highest pressure indicated each timAll three readings must be above pump relief pressure specifications and within 345 kPa (50 psi) of each other. 紧闭阀门三次，并记录每次的最高压力。三次读数均需高于油泵释压规格，且读数间的差异不得高于345千帕(50 psi)。
- Slide the diaphragm assembly into the relief valve seat. 将隔膜总成滑进到安全阀阀座内。
- No valve is to be placed between the relief valve and tank. 在热水器储水罐和安全阀之间不需要安装任何阀门。
- Electrolysis of relief valve seat or first check seats. 安全阀阀座或第一止回阀阀座被电解或电蚀。
- Electrolysis or relief valve seat or first check seats. 安全阀阀座或第一止回阀阀座产生电蚀。
- Must not be smaller than the pipe size of the relief valve. 不能小于安全阀通径。
- Below are some of the typical safety relief valve installations. 下列是安全阀的一些典型安装。
- Remove the four bolts that hold the relief valve cover in place. 拆卸固定安全阀阀盖的四个螺栓。
