您要查找的是不是:
- A DAU hardware block diagram is shown in Fig.3. 数据采集器DAU硬件的方框图如图3所示。
- Design of Multistage Power Amplifier in Ku Band. Ku波段多级功率放大器的研制。
- This simplified block diagram is valuable. 这个简化了的框图很有用。
- Purpose: Medium power amplifier applications. 用途:用于中功率放大。
- DAU hardware block diagram is shown in Fig.3. 数据采集器DAU硬件的方框图如图3所示。
- The block diagram of a battery charger is shown in Fig. 1. 图一所显示的是电池充电器的方块图。
- Purpose: Audio frequency power amplifier applications. 用途:用于音频功率放大。
- Connect the Power Amplifier to Analog Channel B of the interface. 将功率放大器连接到接口上的模拟通道B。
- Purpose: Strobo flash, medium power amplifier applications. 用途:用于闪光驱动,中功率放大电路。
- In some ways, the block diagram resembles a flowchart. 在某些方面,块状的图表类似于一个流程图。
- Figure 1-26 is a block diagram of a typical digital electrometer. 图1-26为典型数字式静电计的方框图。其模拟部分与前面讨论的电路类似。
- In the end, it introduced a new type class-d power amplifier DPPC. 本论文所完成的开关功放已完成样机试验。
- I show all of the circuity and block diagram in this chapter.Also describtion of address converting, power down protecting, power simplifying and so on is given in this part. 在此章节中,作者给出了所有的 线路图及框图,也对系统的地址切换、掉电保护、电源简化等进行了 介绍。
- This paper describes a mathematic mode of unbalanced three-phase power system,derives the formula for broken-line faults calculation and gives the program block diagram. 讨论了三相参数不对称电力系统纵向故障计算的数学模型,推导了有关计算公式,给出了计算框图。
- Purpose: Power amplifier applications, vertical output applications. 用途:用于功率放大和帧频输出。
- The power of the modulated carrier wave is increased by the RF power amplifier. 射频功率放大器增加了调变载波的功率。
- On the File menu, point to New, point to General, and then click Block Diagram. 在“文件”菜单上,依次指向“新建”、“常规”,然后单击“框图”。
- Purpose: Strobe flash applications, general power amplifier applications. 用途:用于闪光灯闪光驱动,一般功率放大。
- Purpose:Low frequency power amplifier,medium speed switching applications . 用途:用于低频功率放大及中速开关。
- I'll demonstrate how to use the power amplifiers? 我来示范一下如何使用这个功率的放大器。