您要查找的是不是:
- Maximum Recurrent Peak Reverse Voltage 最大重复峰值反向电压
- Maximum repetitive peak reverse voltage 最大可重复峰值反向电压
- Maximum peak Reverse recovery Current 最大峰值反向恢复电流
- Maximum peak reverse current full cycle 最大反向峰值电流
- rated non-repetitive peak reverse voltag 额定非重复反向峰值电压
- non repetitive peak reverse voltage 不重复峰值反向电压
- circuit repetitive peak reverse voltage 电路反向重复峰值电压
- rated repetitive peak reverse voltage 额定重复反向峰值电压
- non-repetitive peak reverse voltage 反向不重复峰值电压,非重复性反向峰值电压
- circuit non-repetitive peak reverse voltage 电路反向不重复峰值电压
- peak reverse voltage 反峰电压
- repetition peak reverse voltage 反向峰值重复电压
- repetitive peak reverse voltage 反向重复峰值电压
- The fluorescence spectra (FLS) of CML exited at 280nm and 295 nm showed a maximum peak at 335 nm. 在激发光波长为280urn时,CML的最大荧光发射峰在 335urn处。
- Please Note: The Wattages listed below are maximum peak wattages for each component. 请注意:在下面列出的是对于每个组成设备最大值的瓦数。
- Changed maximum peak data rate per flow to be same as maximum data rate per flow as the peak data rate is lower than data rate on subnet %1. 由于峰值数据速率低于子网%251上的数据速率,将每流程最高峰值数据速率改成了跟每流程最高数据速率一样的。
- Photoluminescence intensity changes as the function of laser power,and the maximum peak at 412 nm presents blue emission. 不同激光功率下沉积ZnO纳米薄膜经500℃热处理后的PL峰,其强度随激光能量而变化,最大发光波长位于412nm。
- The Q-switchings of the DPL involving A-O, E-O, and color center crystals and dye have been realized respectively. The maximum peak output power of the laser is 100 kW. 实现了声光调Q、电光调Q、BDN染料和LiF色心晶体被动调Q的激光输出,最大峰值功率超过100kW。
- Measured at applied forward current of 10mA, reverse current 1.0mA, Reverse voltage of 6.0 voltage and RL=100 ohms. 测试条件:提供10毫安顺向电流;6伏等逆向偏压与100欧姆负载电阻;并于逆向电流回覆至1毫时量得的时间.
- To perform the leakage current test, source a specified reverse voltage, then measure the resulting leakage current. 通过施加规定的反向电压,然后测量产生的漏泄电流,即可完成漏流测试。