您要查找的是不是：
- This paper presents the design, manufacture and test results as well as operation after installation of the flexible joint for 110 kV submarine oil filled cable. 介绍 110 k V海底充油电缆软接头的设计、试制和试验结果 ,以及海缆敷设后的运行情况
- oil filled cable 充油电缆
- high tension oil filled cable 高压充油电缆
- single core oil filled cable 单芯充油电缆
- high-tension oil filled cable 高压充油电缆
- oil filled cable oil 油浸电缆油
- Piston cooling oil inlet low pressure slow-down. 活塞冷却油入口压力低降速。
- Piston cooling oil outlet low flow alarm. 活塞冷却油出口流量低报警。
- Piston cooling oil outlet low flow slow-down. 活塞冷却油出口流量低降速。
- The transformer is available as a self-cooled unit, or it can be purchased with additional steps of forced cooling that use fan or fans and oil pumps. 可选用自冷式变压器,也可购买带有风扇或风扇加上油泵这种强迫冷却措施的变压器。
- Forced cooling air should be used from the beginning of the furnace campaign. 在窑炉作业期开始时就要用空气强制冷却。
- The cool type series uses forced cooling fluid that, when passed through the nut, minimizes heat generation and thermal expansion. 凉爽型系列采用强制冷却液，当通过螺母通过，最大限度地减少热量的产生和热膨胀。
- Widely used in motors, electrical appliance, instrument, etc special equipment winding.Especially suitable for oil filled transformer. 广泛用于电机、电器和仪表等特殊设备绕组。特别适用于油浸变压器。
- Sea water cooling piping for the lub. oil cooler and F.W. cooler oil dirty. 滑油冷却器和淡水冷却器的海水冷却管路有油污。
- Water cooled oil insulated transformer 水冷油绝缘变压器
- Automatic lubricating and forced cooling make sure that extruder performs safely and extends using life. 自动润滑;强迫冷却;确保挤压机安全运转和延长寿命.
- In this paper, the operation process of variable-parameter shutdown and forced cooling of300 MW units in Mawan Power Station is described at length. 详细介绍了深圳妈湾发电厂机组滑参数停机、制冷却的方法及过程。
- Other Constructions: Other filled cable with different insulation, all kinds of armoured cables and different jacket cables will be available according to the site and user's reqiurement. 其它结构:根据使用场合所需、用户要求,可提供绝缘形式不同的其它填充型电缆。可提供各类铠装电缆及不同形式的外护层电缆。
- Compared its application with other units,the application of MHI forced cooling method in Hejin 350MW unit has its unique strongpoint. 而日本三菱公司的强制冷却方法在350MW机组上的很好运用,相比较其他机组其优点得到充分体现。
- This paper presents a test method to the minimum torque of bubmersible motors by an oil filled prototype ,combining with its calculation of the functions ,and gets a right result to verity the computation theory. 结合潜水电机最小转矩的计算;以充油式潜水电动机为样机进行最小转矩的测试;从而验证理论与实践的一致性.
