您要查找的是不是：
- Stainless steel, aluminum. Under the operating condition of deep cooling, the materials of ring and flange bolt are the same. 不锈钢、铝。深冷工况下,环与法兰螺栓同材料。
- Note: 1.Size-Nominal diameter of the valve; D1-Diameter of the flange bolt hole center circle; D-Diameter of the flange bolt holes. 注:1.;规格尺寸为阀门通径尺寸;D1为阀门法兰孔中心分布圆尺寸;D为法兰孔直径。
- All nozzle flange and girth flange bolts shall be of stud bolt type. 所有设备口法兰及翼缘法兰螺栓应为双头螺栓。
- Our most competitive products contains Hex bolt, Hex stock set bolt, Hex flang bolt, Carriage bolt, T bolt, U bolt, Machine screw, Auto screw, Threaded rod, and non-standard fasteners. 六角头螺栓，内六角紧定螺丝，六角头法兰面螺栓，马车螺栓，T型栓，U型栓，汽车螺丝，牙条和特种非标准件等。
- We are manufacturing mainly in: Fasteners: Hex Bolts, Hex Nuts,Flange bolt and Nuts,Carriage Bol... 供应标准及非标准螺栓，螺母，紧固件（图）
- Do not rely on the flange bolting to support the valve or connecting pipeline. 不能依赖法兰螺栓来支撑阀门或连接管道。
- Flange bolts may be tightened by conventional ring spanners on class 150# for utility piping systems. 150号等级的公用管道系统上的法兰螺栓可以使用通用梅花双头板手来紧固。
- Retighten all flange bolts in a star pattern in order to extrude rubber sleeve flange material. 为了将橡胶套管法兰挤出来，需要按照星形模式重新紧固所有法兰螺栓。
- Whenever flange bolts are tightened the torquing sequence must be done in a star pattern (See Figure 5). 在紧固法兰螺栓时，必须按照星形模式顺序（参阅图5）来进行螺栓紧固。
- It is inserted into one end of the glass pipe and the flange bolts are tightened.No extra pipe or fittings are necessary to install a GPI in the line. 将其装入玻璃管一端并拧紧法兰螺栓，在导管内安装玻璃管插入阀时无需额外管道或配件。
- We also offer various high quality special fasteners and stainless steel flange bolts, cross recessed side cut screws, outsize truss head screws with cross recess. 承接各种高品质异型紧固件及不锈钢法面螺栓，切边十字，特大大扁头十字螺丝。
- Leak through diaphragm or around flange bolt holes of relief valve 隔膜或环绕安全阀法兰螺栓孔泄漏
- He locked the door and pressed the bolt home. 他锁上房门，并插好插销。
- The bolt slotted smoothly into place. 插销很容易就插上了。
- Remember to bolt all the doors and windows. 别忘将所有门窗闩住。
- For ease of installation, insert all flange bolts through the valve flange and then through the sleeve flange, but do not let the bolts extend beyond the surface of the flange rubber (See Figure 4). 为了使安装容易些，可以将所有法兰螺栓穿过阀门法兰，然后穿过套管法兰，但是不要让螺栓超过法兰橡胶表面（参阅图4）。
- I rammed the bolt back across the door. 我把门拴上。
- We need an eye bolt to fit this valve. 我们需要一个有眼螺栓来固定这个阀门。
- Flange bolts, hex bolts, machine screws, outsize truss head screws with cross recess, high quality special fasteners, and stainless steel flange bolts, cross recessed side cut screws, etc. 生产(4.;8级、6
- The bolt sheared (off) and the wheel came off. 螺栓折了，轮子脱了出来。
