您要查找的是不是:
- The cycled strain of the alloy is mainly related to the stress amplitude of cyclic loading. 合金的循环应变值主要与合金的循环加载应力幅值有关。
- Method for Determining Appropriate Statistical Models of the Random Cyclic Stress Amplitudes of a Stainless Pipe Weld Metal 确定不锈钢管道焊缝金属随机循环应力幅良好统计模型的方法
- cyclic stress of varying amplitude 变幅载荷
- The calculated results agree with experimental results in terms of stress amplitude impacted by machine stiffness. 就机械刚度对应力幅度的影响而言,计算结果与实验结果一致。
- The effect of pre immersion time on corrosion fatigue life reduced with the increasing of stress amplitude. 在 30MPa下预腐蚀对连接件的疲劳寿命的影响作用比 5 0MPa下预腐蚀对连接件疲劳寿命的作用要明显。
- Corrosion fatigue. A type of failure that results from the simultaneous action of a cyclic stress and chemical attack. 腐蚀疲劳:由循环应力和化学腐蚀同时作用导致的一类失效。
- The results show that low cycle fatigue life is reduced and cyclic stress is raised by torsional prestrain raising. 结果表明,扭转预应变降低低周疲劳寿命,循环应力随扭转预应变的增大而增大。
- Fatigue limit. For fatigue, the maximum stress amplitude level below which a material can endure an essentially infinite number of stress cycles and not fail. 疲劳极限:对疲劳而言,最大应力幅值水平,低于该值材料可以承受无限次应力循环而不失效。
- The ASME code_based evaluation with 20 reduction factor on the mean life is much more conservative than that with 2 reduction factor on the stress amplitude. ASME法中,基于20倍裂纹萌生寿命降低系数的S?N曲线估计结果较基于2倍虚拟应力幅降低系数的估计结果要保守得多。
- The amplitudes of pore pressure increased notably with the increase of cyclic stress ratio, and the residual pore pressure also increased obviously. 当循环应力比增大时,动孔隙水压力变化幅值显著增加,而残余孔压也较大。
- It was shown that the cumulative plastic strain depended not only on the applied cyclic stress and number of cycles,but also on the initial static deviatoric stress level. 在上海地区典型饱和软粘土不排水循环三轴试验的基础上,分析了影响软粘土塑性累积变形的主要因素:循环荷载的作用次数,初始静偏应力和循环加载动偏应力。
- Analyzing the micro plastic deformation of metal material under static load and cyclic stress, The scientific basis for choice dynamical stress of VSR is provide. 本文分析了静载荷及循环载荷下的微塑性变形行为,认为振动时效动应力的选择应以材料的疲劳极限作为依据。
- The results reveal that the solid solution and aging treatments will lead to a change in both cyclic stress response and cyclic stress-stain behavior of the extruded AM50 alloy. 在高的外加总应变幅下,固溶和时效处理可以提高挤压变形AM50镁合金的疲劳寿命,但当外加总应变幅较低时,固溶和时效处理则降低挤压变形AM50镁合金的疲劳寿命;
- Similar cyclic stresses may have occurred due to wind-induced swaying motion during storage. 同样在存放时由风力引起的横向摆动也可以产生类似的循环应力。
- Fatigue. Failure, at relatively low stress levels, of structures that are subjected to fluctuating and cyclic stresses. 疲劳:在相对低的应力水平下,承受交变和循环应力结构的失效。
- Thermal fatigue. A type of fatigue failure wherein the cyclic stresses are introduced by fluctuating thermal stresses. 热疲劳:一种疲劳失效类型,循环应力是由于交变热应力引起的。
- The effect of cyclic stress on the strength of creep rupture and recurrent creep rupture as well as low cycle fatigue of a cast nickel-base superalloy with high Al and Ti contents has been studied under different temperature and stress. 本文对一种高铝钛镍基铸造合金,在不同温度分别测定单调持久、周期持久和低周疲劳性能。
- Cable-grider anchorage zone of cable-stayed bridge was stress concentration and complex,especially should pay more attention to fatigue performance under cyclic stress in operation stage. 斜拉桥索梁锚固区焊接集中,受力复杂,特别是在运营阶段循环应力作用下的疲劳性能值得关注。
- The average is thus a poor representation of the large variability of the stress amplitudes in the crust. 平均的情况则只能较差的反映地壳中应力振幅非常大不同的状况。