该词条未找到_海词词典

您要查找的是不是：

Provides up to 700 mA per channel and 1.0 A total continuous load current 提供每通道高达700毫安及1.;0安的总持续载荷电流
continuous load current 持续载荷电流
Load current is set in 1.56% increments of the maximum value. 负载电流在最大值增量的1.;56%25中设置。
Moisture proof and no contact output, Load current 1A max. 具防潮功能并且采用无接点方式，限时控制负载电流最大1A.
Continuous Load A continuous load is a load where the maximum current is expected to continue for three hours or more (as defined by the NEC for design calculations). 持续负荷持续负荷是指使电流在3个小时或更长时间（根据nec的定义）内需保持最大值的负荷。
The nameplate rating is based on a continuous load producing a 55C to 65 conductor temperature rise over ambient. 铭牌额定值是以产生55℃至65℃导线温升的持续负荷为依据的。
When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate. 订购过载继电器时，请注明每台电机的功率马力、电压和满载电流。
The load current is handled directly by the controller through semiconductor switching devices. 负荷电流由调节器通过半导体开关元件直接控制。
The peak load current limit is set by the user's selection of a reference voltage and current-sensing resistors. 用户可通过选择参考电压和电流感测电阻设置峰值载荷电流限制。
An "Overcurrent Relay" is a type of protective relay which operates when the load current exceeds a preset value. 过电流继电器是继电保护装置的一种，当负载电流超过整定值时，继电器动作。
Choosing the load current phasor as the reference for the phasor diagram analysis is straightforward and effective. 以负载电流相量为参考的新的相量图分析方法是简洁有效的；
The current distribution in fuses is discussed when high frequency components are present in the load current. 还讨论了在负载电流中引入高频分量时熔断器中的电流分布问题。
Consequently, no load current flows through R6 because Q2, whose base-emitter voltage is now 0V, has turned off. 由于Q2的基极-发射极的电压为0V而截止，因此没有负载电流流过R6。
In the test for voltage regulator, the load current of the DUT provided by the test equipment needs a certain delaytime to reach the provision value. 在电压调整器测试中,测试设备提供的负载电流需经一定的时间延迟才能达到预定值。
Synchronous rectification circuitry allows the load current to flow through the low RDS(on) of the DMOS output driver during current decay. 同步整流电路允许负载电流在电流衰减过程中通过DMOS输出驱动器的低RDS(on)流动。
The desired load current level is set via the serial port with two six bit linear DACs in conjunction with a reference voltage. 可通过有两个6位线性DAC串行接口及参考电压来设置期望的负载电流电平。
When the load current is up to the over-current value, the output will stop and the alarm relay will act, and the red LED will light. 负载电流达到过流保护设定值后即:停止输出、报警继电器动作、红色LED灯直亮。
In the ideal power system, the voltage supplying to customer equipment and the resulting load current are perfect sine waves. 在理想的电力系统中,向用户设备供电的电压以及所形成的电流是完全的正弦波。
In the ideal power system, the voltage supplying to customer equipment and the resulting load current are perfect.sine waves. 在理想的电力系统中,向用户设备供电的电压以及所形成的电流是完全的正弦波。