您要查找的是不是：
- biaxial tensile load 双向拉伸载荷
- An Analysis to the Strain Tensor of Osteoblasts Spreading on Substrate in Both Uniaxial and Biaxial Tensile Loading Experiments 拉伸基底加载成骨类细胞内应变张量分析
- The cruciform biaxial tensile test is an effective and practical method to realize the process of complex strain paths. 十字形双向拉伸是实现复杂加载路径有效实用的试验方法。
- Finally, the pivotal question is expounded for the FLSD and the cruciform biaxial tensile test. 最后对成形极限应力图和十字形双向拉伸试验需要解决的关键问题作了阐述。
- We built up a mechanical setup to apply external uniaxial and biaxial tensile strain. 我们建构了一种机制来施加外在单轴或双轴的伸展应力。
- Creep is the manifestation of polymer chain rearrangment under tensile load. 蠕变是在载荷作用下聚合物分子链重排的表现。
- This thesis optimized the biaxial tensile cruciform specimens, developed tensile test method and verified design results by experiments. 本文对十字形双向拉伸试件进行了优化 设计，并对设计结果进行了基本试验验证。
- The cruciform biaxial tensile experiment method was also developed, where the strain in two directions in the central square section is measure by two cross set scale meters. 建立了十 字形双向拉伸试验研究方法， 利用引伸实现了试件中心区两轴变形的动态测量，编制了相应的测控 软件，实现了位移和拉力比例加载及非比例加载。
- The inside buffer plate is to support tensile load, which prolongs the service life of excavators. 臂内安装有内部缓冲板以承受强力负载，从而大大延长了挖掘机的使用寿命。
- A stable tensile load, and at the same time corrosive conditions, can cause stress corrosion. 有稳定的张力负载，同时也有腐蚀性的情况，就会造成应力锈蚀腐蚀。
- So it is feasible to study the deformation behavior of sheet metals along different loading paths by using biaxial tensile test of cruciform specimen with slots on arms designed in this paper. 可见，所设计的臂上开缝十字形试件双向拉伸试验研究不同加载路径下板料变形行为是可行的。
- The effects of material metallur-gy, shot--peening treatment, tensile load, strain rate, cyclic load and water chemistry on the behavior ofSCC are investigated. 研究的影响因素包括材料冶金、表面喷丸处理、载荷、应变速率、循环载荷以及水化学条件对SCC的影响规律。
- Based on the mechanical coupling at the interface between the bolts and the grout medium, an analytical model is developed for fully grouted rock bolts under tensile load. 根据锚杆与锚固浆之间界面耦合机理,分析了岩锚抗拔状态下界面剪应力的分布特征。
- The tensile load of preloaded bolt, often a fraction of external load, could be determined according to the static equilibrium and deflection coordination between the bolt and the clamped parts. 摘要预紧螺栓所受拉力可根据力平衡和螺栓与被联接零件间的变形协调条件确定，其大小变化量为外加载荷变化量的几分之一。
- Study Design. A uniaxial tensile loading study of 13 lumbar porcine ligaments under arying enironmental temperature conditions. 研究设计：在不同环境温度下的13例猪腰椎韧带单轴张力负荷研究。
- Three dimensional finite element analysis with COMEP code was carried out on a plain weave glassfiber composite under tensile loading. 应用有限元法对一种平面编织玻璃纤维复合材料层板在拉伸载荷下的微观应力场作了详细的计算分析。
- This dissertationindicated the tensile loads of wire rope should be considered when quantitativelyevaluating the defect by means of MFL. 为此，本文指出利用漏磁密度定量评价钢丝绳缺陷时应充分考虑钢丝绳张力的大小。
- The mechanical behavior of nano-single crystal and nano-bicrystal copper within (111) atomic layer under static tensile loading is studied with molecular dynamics. 用分子动力学方法模拟了纳尺度铜单晶与铜双晶的(111)面原子的静拉伸力学行为。
- Damage and fracture behavior of self-reinforced polyethylene (PE) composite under monotonic tensile loading were investigated by acoustic emission (AE) technique. 摘要用声发射(AE)技术研究了聚乙烯自增强复合材料的拉伸损伤与断裂行为。
- OPTIMAL DESIGN OF BIAXIAL TENSILE CRUCIFORM SPECIMENS FOR SMART MATERIALS 功能材料双轴拉伸十字板试件的优化设计
