您要查找的是不是:
- The error cost the company one million pounds. 这错误使公司损失了一百万英镑。
- To his rue, the error cost him the game. 让他后悔的是,这个错误让他满盘皆输。
- This error is an absolute error, an angle, and it is measured in deg of rad. 这也是一个绝对错误,可以以角度值度量。
- This paper proposes a progressive approach algorithm based on image cost function to compensate the random phase error in SAR/ISAR imagery. 本文提出逐级逼近算法,基于图像评价函数,对SAR/ISAR中的随机干扰相位进行补偿。
- The 0/1 loss is an important cost function for perceptrons. 1损失是感知器的一个重要的成本函数。
- This is in nature the result of convexity of the cost function. 这在本质上是由于成本函数的凸性决定的。
- Gas weight also has some influence on BHP, the absolute error may be up to 0.77 MPa and the relative error 2.3%. 气体重量对井底压力也有影响;其绝对误差为0.;77MPa;相对误差为2
- Gives a calculation formula of the absolute error of specific frictional head losses. 给出了湍流区沿程阻力系数绝对误差的计算式。
- Graph the three major types of cost functions. 三种主要类型价值函数的曲线图。
- Pearson correlation was used to analyze the absolute error of angle and E/I strength ratio. 以皮尔逊积差相关系数分析整体绝对误差角度与肌力比值的关系。
- This error is an absolute error, an angle, and it is measured in deg of rad and it is the G1-error of the envelope. 这是一个绝对错误,可以用角度或者弧度测量,同时,其曲率包络线也将产生G1错误。
- Mean square error of the linear predictor is used as the cost function to maximize the predictability of the extracted signal so that a source signal with temporal structure can be extracted. 摘要为了分离具有时序结构的信号,将线性预测均方误差作为代价函数,使分离出信号的可预测性最大,这样就可以分离出源信号。
- If the G1-continuity is missed then we have a so called G1-error. This error is an absolute error, an angle, and it is measured in deg of rad. 如果G1连续丢失,将产生所谓的G1错误。这也是一个绝对错误,可以以角度值度量。
- If the G1-continuity is missed then we hae a so called G1-error. This error is an absolute error, an angle, and it is measured in deg of rad. 如果G1连续丢失,将产生所谓的G1错误。这也是一个绝对错误,可以以角度值度量。
- A new cost function based on the diagonalization of correlation matrices is proposed to measure the independency of output signals. 摘要提出了一种新的基于相关矩阵对角化的代价函数作为衡量输出信号独立性的测度。
- If the G0-continuity is missed then we have a so called G0-error. This error is an absolute error, a distance, and it is measured in mm or inches. 如果G0连续丢失,将产生所谓的G0错误。此错误是一个绝对错误,一个距离值,可以测量。
- We would rather have several small absolute errors than one large one. 我们宁愿要几个小的绝对误差,而不要一个很大的误差。
- Under the MRF-MAP framework, the Iterated Conditional Modes (ICM) was used tosolve the cost function. 介绍了在MRF-MAP框架下,采用条件迭代模式(ICM)求解值函数的方法。
- An approximate minimizer of cost function is found by using matching pursuit algorithm,and the filters are selected. 利用匹配追踪算法找到了一个近似最小的代价函数,从而选出了滤波器。
- "On average, subjects felt the scenario took about 43 seconds longer than it actually had.The mean absolute error was 163 seconds, or about 2.5 minutes," Dr.Eisen said. 平均来说,受试者认为的时间长度比实际上多了43秒,平均绝对误差为163秒,或大约是2.;5分钟。